DoView has been optimized to allow you to dataproject your model when it is broken up into compact 1 x 1 pages. This is a key part of DoView being designed to make building models with groups easy. Many  dataprojectors use a 1024 x 768 screen resolution which is somewhat smaller than the setting of most desktop and notebook computers. The compact 1 x 1 page in DoView has been designed to be able to be viewable when dataprojected on a 1024 x 768 resolution on a normal-sized screen in a medium-sized room.

 

The resolution of your dataproject is set from your computer. You can tell which resolution your dataprojector is set on by looking at a compact 1 x 1 DoView page when dataprojected onto a screen. If some of the compact 1 x 1 page is obscured when the Page list is showing, then you are on the correct resolution (1024 x 768). If you can see all of the page when the Page list is showing, then you are probably on a too high a resolution. While higher resolutions may be fine on your desktop or notebook computer, when your DoView model is dataprojected, it will mean that the steps and other elements on the DoView page are likely to be smaller than they would be if you used a 1024 x 768 screen resolution on your dataprojector.

 

To change the screen resolution in Windows XP you go into Control Panel > Display. In Windows Vista you go to Control Panel > Appearance and Personalization > Adjust screen Resolution.

 

Just set the screen resolution to 1024 x 768 and the steps and other elements on the DoView page should get a little larger so that people in the audience can see them more easily. In 1024 x 768 screen resolution close the page list so that you can see all of the page.